Last Sunday the sun was shining and lifting my spirits, almost perfect weather for drying hand-made papers, something I haven’t done for a few months now but it was so much fun I can’t think why I have left it so long.

I thought I would share my method with you as I think it is much easier than the mould and deckle method most people / books teach. For my method you will need:

• a paper-making mould (this can be an old picture frame with some fine mesh stapled across the opening)
• some shredded paper (I use photocopier paper with printing on it but any paper that’s not too shiny should work fine)
• some inclusions (optional), I have used flowers and tea bags but the world is your oyster here. Acrylic paint or food dye can be used to give a more uniform colour but I like how the colour from many flowers “bleeds” through the paper.
• a blender or food processor
• boiling water and a sink or tub large enough for your mould / frame
• a sponge
• some old towels

This is a selection of my dried inclusions. I keep a saucer in the kitchen and add things that I think might make interesting inclusions, here I have some used tea bags, a variety of seed heads and some dried flowers rescued from dying flower arrangements destined for the compost bin.

For an A4 frame (US letter size), put approx. 300 ml of shredded paper into a blender or food processor and cover with boiling water. 300 ml of paper will give quite a thick sheet of paper, try using less for thinner paper (but this requires a little more skill to make sure you don’t end up with holes).

Let it soak for a minute or two while you part fill a sink with cold water and lay the paper-making mould in it, mesh side down. The mesh of the frame should sit just beneath the surface.

Whiz the paper at a moderate to high speed for 5 seconds to get a smooth pulp. Add your inclusions and whiz briefly to mix.

Pour the pulp across the mesh surface of the frame, rinse out the blender pouring the solution over any thick areas of pulp in the frame to thin them out. Give the frame a little jiggle while it is still the water to even out the pulp.

Carefully lift the frame out of the water keeping it level, wipe a sponge across the base several times to remove excess water, lay the frame on an old towel (this will help remove so more water).

Place piece of blotting paper over the wet pulp.

Gently tap the blotting paper all over with your finger tips until it is evenly wet:

Note: using coloured blotting paper will transfer some of that colour to one side of your paper, if you can get white blotting paper this is better.

Turn the frame the other way up over a dry towel and tap the mesh until the pulp starts to detach (as it has in the bottom of this photo):

Keep tapping the mesh util the pulp has completely detached from the mesh and leave your paper to dry.

These are my papers drying in the spring sunshine:

When completely dry, the blotting paper is carefully peeled off, and your new paper can be ironed to flatten it.

My finished papers:

Do you make your own paper? I would love to hear your tips and favourite inclusions in the comments below. Likewise, if this tutorial has inspired you to have a go, I’d love to see your results 🙂